Close the flow.
Close the flow. A frame is set telling the server in the other side to stop sending responses to the messages associated with this flow.
true
if the command succeeded (because the flow was open).
Return whether this flow is open.
Open the flow.
Open the flow. A frame is set telling the server in the other side to start sending responses to the messages associated with this flow again.
true
if the command succeeded (because the flow was closed).
A "client flow" is an abstraction created to enable selective flow control, which is a way to ask the server in the other side to stop sending responses of a certain kind. The need for selective flow control comes when the client can receive back-pressure using some subset of the responses. Proxy servers are a prototypical case: when sending the responses to the front-end, some clients can slow down (the slowness can come from the themselves or from the network) and the proxy must either buffer the data, discard it, or tell the back-end to stop sending it.
If there is no need to be selective, there is no need of explicit flow control, as it is simpler to rely on TCP for that (not reading, and causing "zero window" notifications). This is the most common case.
Instances of this class are created by the Mot client, and are used opaquely: each request is associated with a flow (which defaults to the main flow). The client can then use the flows (of which it must keep references) to stop responses selectively: "closing" a flow instructs the server to do not send the responses of the messages that were associated with that particular flow. If flow control is not used, there is only one instance of this class, which is always created (the "main flow" with id 0).
This mechanism only applies to responses. Requests do not need it, as it is always possible to respond them with an application-level indication to stop. This is not the case with responses, which could only be discarded. (In the proxy case, additionally, it would be impossible for the front-end to know in advance which is the final target of a request).
It is also worth mentioning that no response is stopped half-sent: Mot is a small-message protocol and each message (that cannot use more than one frame) is always sent entirely o not at all.
mot.protocol.FlowControlFrame