ConnectVoltageLevelOnLine |
This method cuts an existing line in two lines that will be created and connected to an existing voltage level
(also called switching voltage level).
|
ConnectVoltageLevelOnLineBuilder |
|
CreateBranchFeederBays |
This class allows to add a new branch's feeders on existing busbar sections.
|
CreateBranchFeederBaysBuilder |
|
CreateCouplingDevice |
Adds a coupling device between two busbar sections.
|
CreateCouplingDeviceBuilder |
|
CreateFeederBay |
This method adds a new injection bay on an existing busbar section.
|
CreateFeederBayBuilder |
|
CreateLineOnLine |
Connect an existing voltage level (in practice a voltage level where we have some loads or generations) to an
existing line through a tee point.
|
CreateLineOnLineBuilder |
|
CreateVoltageLevelTopology |
Creates symmetrical matrix topology in a given voltage level,
containing a given number of busbar with a given number of sections each.
|
CreateVoltageLevelTopologyBuilder |
|
RemoveFeederBay |
This modification removes the whole feeder bay related to a given feeder connectable.
|
RemoveFeederBayBuilder |
|
RemoveHvdcLine |
|
RemoveHvdcLineBuilder |
|
RemoveVoltageLevel |
|
RemoveVoltageLevelBuilder |
|
ReplaceTeePointByVoltageLevelOnLine |
This method transform the action done in the CreateLineOnLine class into the action done in the ConnectVoltageLevelOnLine class :
it replaces 3 existing lines (with the same voltage level at one of their side (tee point)) with two new lines,
and removes the tee point
|
ReplaceTeePointByVoltageLevelOnLineBuilder |
|
RevertConnectVoltageLevelOnLine |
This method reverses the action done in the ConnectVoltageLevelOnLine class :
it replaces 2 existing lines (with the same voltage level at one of their side) with a new line,
and eventually removes the voltage level in common (switching voltage level), if it contains no equipments anymore, except bus or bus bar section
|
RevertConnectVoltageLevelOnLineBuilder |
|
RevertCreateLineOnLine |
This method reverses the action done in the CreateLineOnLine class :
it replaces 3 existing lines (with the same voltage level at one of their side) with a new line,
and eventually removes the existing voltage levels (tee point and tapped voltage level), if they contain no equipments
anymore, except bus or bus bar section
Before modification:
|
RevertCreateLineOnLineBuilder |
|
TopologyModificationUtils |
|